Greetings to every dedicated member of the jewelry community,
Hope everyone is ok and crafting.
I really thank God for the sunny weather that we experience today.
For some days now, it's been raining seriously and some activities has been hindered,
But today was totally different as I was able to wash and sundry some clothes today.
Being bored and thinking of what to write, I quickly remembered that tomorrow is Sunday and I will be having some visitors, who will be visiting my baby.
I need to look good , so I decided to bead a bracelet for myself.
"But what kind of bracelet will look beautiful on my red gown" , I thought to myself.
Without further delay, I open my phone and head straight to some YouTube channel ,
After searching for a long time, I finally found something that captured my attention.
What captured my attention was the wire design in-between the pearls, it looked very creative and beautiful as well and I decided to try it.
Am glad that I was able to get something similar to it and beautiful as well.
Below are the material that I used to accomplish my goal ...
 |  |
|---|
- A handful of white Pearls bead
- Scientific or binding wire
- Measuring tape
- Scissors
- Bracelet hook
I wanted to used an orange bead but considering my outfit on Sunday I felt it would be nice to use white and moreover,
White is versatile, it blends perfectly well with any color .
Now below are the steps that I used to acquire this beautiful bracelet.
To bead my bracelet, I measured out 50inch of my binding wire using a measurement tape,
Using a scissors I cut it out.
I measured 50inches because I wasn't sure of the length of wire to use and moreover, it is better to have excess wire than to start afresh if my wire wasn't enough.
 |  |
|---|
I put my bracelet hook at the middle of my binding wire and squeeze the wire very tight.
 |  |
|---|
I used the binding wire to collect about 48 pearls bead .
I knew that is too much but i wanted to remove the excesses when am done.
 |  |
|---|
After adding the pearls bead, I began crossing and squeezing the wires in-between the beads which resulted to the design on the bracelet.
When It got to the length that I need, I immediately remove the remaining beads.
 |  |
|---|
Using the end of the binding wire, I tied it to the other end of my bracelet hook, and used my scissors to cut the excesses.
My bracelet is ready and Sunday activities are secured 😁.
While squeezing the wires , I got scared that my wire might cut and I would start afresh, the bracelet was indeed beautiful and worth my time,
I hope you like it .
All photos are my property
Thanks for reading till the end.
Yours faithfully:
Yummycruz1.
