I have placed the active key into the code. I'm going to have to dig a little more to figure out where I went wrong at.
You are viewing a single comment's thread from:
Sort: Trending
That would show up on HiveBlocks right? I'm sorry if I'm not grasping the terminology.
Yes, if you try again with the active key I think it will work. After you try it should show on hiveblocks with any error or success if it consumes RC.
So just the active key or both keys? I'm still having the same problem its being signed locally I believe but not reaching a Node... I think. I'm not 100 percent sure.
Maybe just the active, it is still showing the same error but it did hit a node and try to post. Recent attempt here
No problem at all, I still have no clue how to set any of the stuff up through python. So you are helping me learn through trying to help you.
Is there a way to add wait 3seconds, check block id, then check bal? It looks like you are burning a ton of rc on failed transactions at the moment.
Maybe. I'll go back and clean it up, maybe add a few minutes in between.
The bot is working now though you were right about the active key... I was missing forcing it later in the code.